ABY-C100 computer network lightning protector
Network lightning protector of computer network surge protector ABY-C100
ABY-C100计算机网络防雷器
网络防雷器计算机网络电涌保护器ABY-C100
The scope of application
Sensitive communication network lines of various computer network equipment, switches, routers, HUB, MODEM etc.. Use it from voltage, lightning induction power supply interference, electrostatic discharge damage.
Principle:
Using the two poles of protection, the first stage is used for coarse protection, Huineng; the second level for the fine protection, is used to clamp. Before and after the two grade through coupling, the lightning protector really play the ideal effect of lightning protection.
The characteristics of:
Variety complete, equipped with different products, different interface;
Low insertion loss, low residual voltage;
High transmission rate of 10 ~ 155 (Mbps);
Beautiful appearance, convenient installation.
适用范围
各种计算机网络设备、交换机、路由器、ＨＵＢ、ＭＯＤＥＭ等敏感的通信网络线路。使用其免受雷电感应过电压、电源干扰、静电放电特所造成的损坏。
原理：
采用前后两极保护，第一级为粗保护，用于汇能；第二级为细保护，用于钳位。前后两级通过耦合，使防雷器真正起到理想的防雷效果。
特点：
品种齐全、配备不同的产品、不同的接口；
插入损耗小，残压低；
高传输速率１０～１５５（Mbps）；
外形美观，安装方便。
Technical parameters: 技术参数：
|
Model 型号
|
ABY-C10
|
ABY-C100
|
ABY-C100*
|
ABY-C10*
|
|
Working voltage
工作电压（Ｖ）
|
5
|
5
|
5
|
5
|
|
The characteristic impedance (ohms)
特性阻抗（欧姆）
|
|
100
|
50；75
|
100
|
|
Transmission rate
传输速率（Mbps）
|
10
|
100
|
100
|
10
|
|
Insertion loss
插入损耗（dB）
|
0.2
|
0.5
|
0.5
|
0.2
|
|
The nominal current capacity
标称通流容量（KA）
|
|
10
|
|
|
|
The maximum flow capacity
最大通流容量（KA）
|
|
20
|
|
|
|
Resistance voltage
阻制电压（V）
|
|
20
|
|
|
|
interface 接口
|
RJ45
|
RJ45
|
|
user requirer
|
|
protect the feet
被保护脚
|
1、2；3、6／all 全针
|
1、2；3、6／all全针
|
|
|
|
Size 外形尺寸
|
88*25*25
|
88*25*25
|
120*25*25
|
|
Installation method:
1, look for the interface and connection mode.
2, lightning protection device is connected in series between the signal channel and the protected equipment.
Input 3, lightning protection device (IN) is connected with the output end of the signal channel, (OUT) is connected with the protected equipment.
4, reliable grounding, ground to short, coarse, straight, in order to reduce the influence of lightning releasing the distributed inductance.
5, this product needs no special maintenance. When the system works when a fault occurs, can be dismantled for lightning protection device, if can return to normal, replace the lightning protection device.
安装方法：
１、认准接口及连接方式。
２、防雷器串联在信号通道和被保护设备之间。
３、防雷器的输入端（ＩＮ）与信号通道相接，输出端（ＯＵＴ）与被保护设备相接。
４、接地可靠，地线力求短、粗、直，以减少分布电感对雷电汇放的影响。
５、本产品无需特别维护。当系统工作出现故障时，可拆除防雷器，工作若能恢复正常，则应更换防雷器。
ELECTRIC
